How to improve the kill-switch
Here we can show you how you can improve your kill-switch, in most cases the throttle grip wear out and often have to be replace with new. So, in this case you can use your throttle grip for long. See the pictures bellow.
The chain touches the camshaft cover
Here in this post you can see another tricky way how you can stop a noise from the camshaft cover. See the picture , originally there is with right base, you have to use grander and to sanding the part like a curve . This is very important part of installation and you can safe future issues.
How to connect electric cables
There is some useful information about electric system. This information missing in the manual book
You have to connect blue cable with blue and the yellow cable from kill switch have to be connect with blue cables. Black with black and green cable from kill switch have to be connect with black cables. The white cable is for lights, but my recommend is don't use it, just insulate it. If the wires be exchanged you will broke all electric system, this including kill switch, CDI -Ignition & magneto coil. This does not happen immediately, but after few minutes maybe half hour the engine just stop. Its very important how will connect the cables.
How to clean & prepare magneto coil
In this post will show you how to clean magneto coil of new or used engine. In most cases the metal is coated with lacquer and connection is bad. Take piece of sandpaper and just cleаn surfaces. / see the picture below/ then insert the screws and make adjustment. Its easy way to do it and will save you hassles in the future.
